Problem with WD Marvel Demo

[Vlad]

[/b]locarno[/b]
If you take a drive, so take a look at PCB and connectors are on top
From left to right
Power connector, SATA, small 4-pin connector

1 Power off drive
2 Install two jumpers in a 4-pin connector
3 Using wire, connect the jumpers to the drives ground
4 Power On
5 Show screenshot of WDMarvel with the selected needed controller

[locarno]

look up. I can't use jumper's
Is other pin size

[Vlad]

Use jumpers that smaller

[locarno]

Hmm. I don't have smaller jumper's
Any alternative ? Can I connect pin's by wire ?

[Vlad]

Yes, use wire

[locarno]

Please wait.

[locarno]

Connect PCB with disk ?
Or connect only PCB ?

[Vlad]

With disk

[locarno]

Ok. I'm enable computer

Windows boot. What next ?

[locarno]

925 880 395
9064

Please connect