A question

[Vlad]

Isolate contacts from PCB to the preamp with some plastic card
Power on
SA region editor
Add +1 to all region and Dir addresses
Ok
Power off
Remove isolator
Power on
SA region editor in RAM
Restore all addresses
Reinit module 01
Now you can read password in config editor

But you need full version for this

[tehnosoftex]

Isolate contacts from PCB to the preamp with some plastic card
Power on
SA region editor
Add +1 to all region and Dir addresses
Ok
Power off
Remove isolator
Power on
SA region editor in RAM
Restore all addresses
Reinit module 01
Now you can read password in config editor

But you need full version for this

I can buy for a month, but it will works for sure?

[manager_lg]

I can buy for a month, but it will works for sure?

Sure, you bet.

[tehnosoftex]

Just payed on paypal, this is the receipt
1NG10249G6107092V
thanks

[Vlad]

Give me to know is something went wrong

[tehnosoftex]

It does some thing but I think I don't follow the steps properly. I isolate the preamps and add +1 to all region and Dir addresses. after that power off remove the isolator and start the pc. You tell me 'SA region editor in RAM', so I must go into the ram menu and click edit sa regions map in ram? but I get error reading the region map. If I go to s/a operations s/a regions operations i can restore all addresses. If I restore all addresses go to modules operations and find modules 01 ff , the hdd is restored to normal operation but do not find any module. Please bare with me, I am not an hdd tech, I only try to make this one running and learn some new things.
https://ibb.co/rwQW3r6
https://ibb.co/z7wKZQZ

[Vlad]

Show with teamviewer

[tehnosoftex]

in a moment to change s/a addresses again

[tehnosoftex]

Now I am ready for teamviewer, i've sent the details by pm

[Vlad]

Drive was not a password protected, it have SED lock...