A question

[Baraka]

Ok thanks Vlad.

I am trying to access data on a WD3200BEVT-11A03T0 (PCB 701609) with failed PCB. I have a donor working 701609 PCB from the same model drive, but the donor has a different ROM version, and I can't find a ROM that is compatible with the patient drive to get it to initialise properly.

Using the donor PCB, I can get the drive to a ready state and read all firmware, but drive shows as 0lba. The modules on the platters which usually contain the ROM modules are all Not Init, so I can't rebuild rom from firmware on the platters.

According to Module 11 the firmware version is 5002B. Does anyone have a ROM version 5002B from a WD3200BEVT-11A03T0 they'd be kind enough to share?

[Peter_M]

Baraka you can rebulid from Module 40, ROM module 47. 4F you can adapt from donor ROM, 30 module tshi si Plist SA ypu can adapt from donor ROM.
And Same ROM you can via Terminal in boot code using china Soft on internet you can find it.

[Beamg]

So, I have a few more questions.

Vlad,

After ARCO and SelfScan pass with new factory FW, how do you enable the ATA security function again? I tried ticking the check box in config mod 02 to change security to supported.
However, it still won't accept passwords via ATA.

Also, what does ARCO error code 72ED mean? This error occurs during the RWGap Calibration test.

BTW, I just found the factory FW package for the HubbleLT2 500GB drive! Which contains mod04. Why were you hiding it? Currently testing it out.

[galaxy]

how to solve slow issue in new charger drive

[Vlad]

You need to buy unlocked PCB

[bloods]

hi everyone, sorry for my bad english

my notebook is broken few days a go, my disk have a ata password and i know the password.

i put the hdd on another notebook (4 different brand and model) and these notebooks not accepts my true password


i already tryed zu , mhdd (with usb not floppy) ,ultimate bootcd and no lucks

please help me , i need my files in drive

and i try english demo version of wdmarvel (clear password section) but no lucks

WD5000LPCX
WD5000LPCX-00VHAT0


thanks everyone

[elevtechlift]

Greetings all!
I just downloaded the demo software. I know it's read only but how do I read and backup the necessary modules and/or data from SA for future ROM rebuilds? Can this process be done with a HDD connected to a USB dock or do I need to directly connect the HDD to the PC motherboard's SATA/IDE or via PCI/PCIe?

[SRUTSSSSSSSS80]

directly connect the HDD to the PC motherboard's SATA/IDE or via PCI/PCIe

[elevtechlift]

directly connect the HDD to the PC motherboard's SATA/IDE or via PCI/PCIe

Thanks again for the clarifications! Will this process also work via eSATA/eSATAp? Does eSATA/eSATAp also work to write ROM content if I bought a full version of WDMarvel?

[SRUTSSSSSSSS80]

eSATA - YES